Gun Porn July 2019

This first one started life as a model DD gun (or kit) from Cobray/Leinad. The owner rounded the grip frame for an old timey look, added an under-barrel lug, built custom then color case hardened the frame.
The builder posted the pictures on the Derringer Forum, see it here

This beautiful Ruger GP100 is from Reeder Custom Guns

Pretty sure Doug Turnbull's team is responsible for this one 

The 1911 pistol below comes from the folks at Standard Manufacturing, visit their website here

Another beauty from Turnbull

One of the thousands of guns on display at the National Firearms Museum. If Fairfax Virginia is too far for you to travel, fear not, they have dozens of high resolution images on their website.

The pictures above were found freely on the world wide web and are used under the guidelines of Fair Use, per Title 17 of the U.S. Code. Where possible the source has been credited. If you own the copyright to any of these images and wish them to be credited or removed, please contact me immediately. 

The Stevens model 73 Project part 3

If you missed parts one and/or two, click on the links below

Part One
Part Two

Now that the wood is done, we need to get the steel parts ready for bluing. I start on the barrel by removing the sights

Then I begin polishing with 100 grit cloth backed sand paper. I polish the metal both radially and longitudinally, alternating until the pits are nearly gone, then move up to the next grit.

This is 220 grit....

Finishing with 400 grit

Next we clean up the small steel parts

We'll start with the mangled take down screw

After taping up the threads, I put it in my vice and tapped down the distorted metal with a ball peen hammer

Then I use a needle file to clean up the inside edges

Then I chuck it into my cordless drill and clean it up using sand paper, finishing with 600 grit

I used the wire wheel on my bench grinder and sand paper to clean up the remaining small parts

Then the parts get blued, I blue my parts in a bath of salts heated to 290 degrees (Sodium Hydroxide & Sodium Nitrate)

Time to reassemble the bolt, the roll pin that held in the extractor and extractor spring was too short and was beat up, I replaced it with a new stainless 1/16" roll pin

After installing, I filed it down flush on both sides

The firing pin goes in a channel on the side of the bolt, it is held in place by deforming the metal with a chisel

I had to polish the aluminum surface inside the receiver housing, the barrel to receiver fit was very tight

Before final assembly I wanted to clean up the receiver and trigger housing with a fresh coat of satin black spray paint. Cerakote would have been better, but I am not going to spend $100 to Cerakote a $75 rifle.

Finished

Before and after

I decided this thing needed a sling, I had this old leather belt that had two rows of holes punched along its entire length. So trimmed one end and ordered up some brass Chicago bolts.

after a little Neatsfoot oil on the sling I installed it and got some more pictures:

Project Costs:
Rifle purchase price: $14.00
Used bolt: $36.00-$30.00 refund = $6.00
NOS extractor: $13.99
NOS firing pin: $20.95
Savage butt plate: $1.00
Butt plate screws: $0.50
Sling swivels: $2.88
Extra Bolt: $1.00
Sling: $0
Chicago Bolts: $2.46

Subtotal investment: $62.68

Extra Bolt sold: -$40.00

Total Investment: $22.68


On to the next project!