Anyway, My Father in law found this at a yard sale for $40 (this seems to be a common price for used, beat-up shotguns). This Remington model 58 Sportsman was the 1st gas-operated shotgun produced by Remington.
There were approximately 271,000 model 58s made between 1956 and 1963 when the gun was later replaced by the model 1100 in the Remington line-up.
The serial #s started at 1000 and went to 275,000. Mine has a serial # of 36xxx which should put it in the 1st year of production.
Here are the before pictures
The trigger looks gold in the above photo, that is actually rust, I think it was originally chromed
The pink spots are just ol' Iron Oxide
I have read that both the butt stocks and the receivers on these guns have been known to crack under heavy use. Luckily my gun shows no signs of any cracking.
Before stripping the metal for rebluing, I thought I would see if I could clean up the metal with 0000 steel wool and some Rem Oil.
It didn't look too bad, and if I was just a regular Joe I might have left it like that....
So here is what I plan to do:
1. Strip and polish the metal to a high shine and then reblue the steel parts using the hot salts method.
2. Polish the bolt and jewel it
3. Strip and polish the aluminum trigger housing
4. Polish the trigger
5. Do something with the grip cap, repaint with black and gold or black and silver....
Step one is always dis-assembly. These guns do not come apart like any other shotgun that I have had the pleasure of working on.
First, remove the two pins holding the trigger assembly in the receiver....this part is familiar.
This guns design uses a gas piston that is stored in the front portion of the magazine tube (this is also why the model 58 only holds 2 rounds in the magazine).
So in order to free the action bar from the piston, you need to remove the end cap, push the piston back a bit and line up the piston/action bar connector with a notch in the mag tube, this will separate the two
Then remove the charging handle (just pull hard, it is held in by a ball & detent). Next slide the whole works out the front of the receiver.
Next remove the butt stock...the screw is just where you would expect to find it, not sure what the second hole is for though.
Incidentally, the model 58, 870 and 1100 all use the same butt stock.
So I have everything apart....where to start?
I decided to start with the trigger assembly. The housing is anodized aluminum and since I have not yet mastered the art of anodizing, I figured I would strip and polish the aluminum housing.
While I was at it I polished the hammer surfaces where it rides against the bolt and where it slides into the dis-connector.
Since I will not be bluing for awhile yet, I figured I would reassemble the trigger group now. I would probably not remember how it went together a few weeks from now.
I have to make this mess of parts into a working trigger assembly again.....yikes
After some cursing and internet searching for a picture of the assembly, I was able to get it back together...correctly.
Of course, I put it together incorrectly at least a dozen times.....I can safely say that I am an expert now.
I used naval jelly to remove the old bluing and rust.
the wire wheel on my grinder cleaned up the residual acid
about 1/2 way done, this is a 400 grit finish, it goes much faster once you get past 400 grit, but you need to keep checking to make sure you did not miss any pits
The receiver is done, this is a 2000 grit finish, I'll go back over it to make sure no visible pits are left
I then went to work on the barrel, the mag ring had some pits that took some file work to get out
after sanding I started buffing
Ready for bluing
|As I do with many of my projects I like to post pictures of what I hope the gun will look like when finished: here are some really nice Remington model 58s